Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot 308 key fob stopped working one day, it could be due to a dead battery in the coin or water damage, receiver module issues or a defective electronic chip. These are all simple fixes that can restore your car to speed in no time!
Car keys can also get damaged due to the blade getting worn. It is easy to fix by visiting your local Car Key Man Auto Locksmith and let them fit an entirely new key blade for you.
Battery
The battery of the key fob in your Peugeot 308 can sometimes die or become weak enough to send an effective signal to the car. This can cause the key fob's function to cease and prevent you from opening and locking the doors, or even starting your engine. To fix this issue, you'll have to replace the battery on the key fob.
You can buy a brand new battery at an auto parts store or at your local hardware store. Make sure that the battery is brand new and not stored on the counter for too long. A new battery has more capacity and can transmit a stronger signal your vehicle.
After replacing the battery Try locking and unlocking the doors of your Peugeot with the key fob. If the doors do not unlock, the problem is likely with the car's receiver module, which can be reprogrammed by your local Peugeot dealer.
It's also possible that the chip inside your key fob is damaged. You can harm your key fob if you drop it on the ground or expose it to water. G28 Car Keys that shield your chip from moisture may become worn out over time. This is especially the case when you expose your key fob to water for prolonged periods of time, like submerging it in the ocean. To prevent this from happening, it's important to keep your key fob away from water and never let it come into contact with water.
Water Damage
If your key fob is soaked in water, regardless of whether you dropped it in the pool or fumbled it into a puddle, don't think it's a loss. The key fob is protected by rubber seals however, prolonged exposure to water may affect the electronic chip. Since water is a good conductor so any water that gets inside the key fob can cause a chain of short circuits that will eventually damage the chip. After taking the battery out, clean the contacts with isopropyl ethanol and dry it off completely before putting it back into.
A dead battery could be the reason that your Peugeot 308 won't start. If you have an extra vehicle, jumper cables may be used to get the engine running again. If the battery has a problem and needs to be replaced, it should be replaced.
A defective receiver in your car may also block it from receiving the signal from the keyfob. It could be due to a issue with the antenna, or wiring, or the key fob might be damaged. If you are using an entirely new key fob, it might need to be programmed to your vehicle. If you cannot fix the issue on your own then contact a professional technician. A trained technician will be able to find the issue quickly and fix it immediately.
Radio Interference
Interference can result in symptoms such as a key fob that's not being recognized or has a limited range. The interference can be radiated or transmitted, the latter resulting from power and speaker cables getting too close to electrical components. In general, rerouting cables and moving them away from these components will fix the problem.
It's unlikely that someone is watching your key fob signals to steal your car, but it's possible that your signal has been drowned out by radio frequency interference. This is a simple problem to fix.
If your key fob is not being recognized by the system, you can try replacing the battery. Make sure that the battery is of the correct size and type. Batteries that aren't the correct size can damage your fob.
These devices could interfere with the key signal if they are using the same radio frequency. It is best to avoid using these devices with your key fob.
Pairing Issues
The remote keyless entry system is an antenna that receives radio frequency signals from the key fob. You will not be able start your vehicle if the receiver is not functioning properly even if the key fob is working and is reprogrammable. This issue can be caused by a variety of ways, including an inoperative battery on the coin-cell or water damage. The receiver could also be malfunctioning due to an error in the software or internal damage to the key itself.
One of the most frequent reasons for why your Peugeot 308 key fob isn't functioning is because the battery inside has failed. This battery can be replaced, but you need to be sure it's the correct battery for your keyfob. It is best to choose an item that has the same size as well as voltage and specifications as the original.
Another reason why your Peugeot 308 key fob might not be working is that it has been paired to a different car. It is possible that you have accidentally given your key fob a friend or it was used to unlock other vehicles. It is possible to fix this issue by reprogramming the key fob with an OBDII scanner. This tool will ask for details about your car, such as its VIN or engine type. It is essential to enter the correct details.